Nzxt aer rgb 2 kit8/15/2023 ![]() If everything is correct, you can turn them on and marvel at their splendour. Once your fans are in place and everything is cabled up, there’s one last task: make sure no wires are poking into the fans when you turn them on, as this is a good way to slice up your cables. Ultimately, I changed the orientation of the fans, ensuring my case’s airflow worked as it did before but hiding some of the RGB lighting. I had planned to have the fans mounted at the front and facing inwards, but that made the fans exhausts instead of intakes. Note that the RGB lighting is on one side only, so you may need to change your case’s airflow if you want the lighting to be easily visible from one side. Once everything is connected, you’re ready to actually place your fans within your case (if you haven’t done this already). Thankfully, the Manta case we’re using does have a lot of extra internal space to play with and the cables are quite thin, so it’s not the end of the world. Again, there’s no groove to route the cables on the fans, so these cables also have to sit somewhere outside. (This means there’s one slot left on the Hue+ you can use for something else, e.g. Basically, you have to run cables from the Hue+ to your first fan, then from the first fan to the second fan, and so on until all of your fans are connected. ![]() I opted to put the power connectors on the same side of my case as my motherboard, keeping them out of sight. Normally there’s an inset area on each corner that allows you to route the cables easily, but the completely cuboid shape of the Aer fans means that you need a little extra space along the outside for your cables to run. Next, you have to hook up the four-pin power connectors for each fan. The lesson here is this: make sure you have a spare USB 2.0 header on your motherboard, and get an expansion board like the one linked above if you don’t. Once that arrived (thanks, Amazon same day delivery), I was ready to connect the Kraken and Hue’s USB headers to the expansion board, mount that in the PC, and finally plug that into the motherboard. I didn’t have a spare connector on my my motherboard - it was already used by my NZXT Kraken X61, go figure - and so I ended up needing to buy an NZXT Internal USB Expansion for £15. There’s a Molex power cable that plugs into the Hue+ - no worries there - and also a Micro USB to USB header cable. The obligatory internal USB 2.0 expansion Aer RGB140 & HUE+: 2 x Aer RGB140 with HUE+ Controller - £89.99. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |